Tidy up your workshop using our magnetic attachment system for dust extractors.
- Fits over any 100mm extractor inlet
- Fits over any 100mm outlet on woodworking machinery
- Secure with the metal hose clamp
- Butterfly thumb screw (no tools required)
- Other end has a steel ring ready to accept a magnetic connector
Pair with MAG100 connector to use with 100mm diameter extractor hose.
Pair with MAG63 connector to use with 63mm diameter extractor hose.
Tidy up your workshop using our magnetic attachment system for dust extractors.
The rubber cuff is designed to fit snugly over any 100mm outlet or inlet. Being made of flexible material it will cope with slight sizing variations seen between different manufacturers.
It can be fitted over the inlet on any extractor with a nominal 100mm (4″) diameter.
It can be fitted over the outlet of any woodworking machinery with a nominal 100mm (4″) diameter.
A metal hose clamp sits in a recess and can be tightened using the butterfly thumb screw (no tools required).
On the other end is a steel ring ready to accept a magnetic hose connector. When joined they form an instant airtight seal.
When used as a pair, a hose can be instantly installed or removed completely. It gives a practical option of using a single hose and switching between different machines as required, rather than installing a permanent branch system.
It is a massive benefit to smaller workshops where hoses left running across the floor represent an annoyance or maybe even a trip hazard. Using magnets on both ends of the hose allows the complete hose to be removed and hung on a wall.
It also allows a workshop to have 2 different lengths of hose ready to use in an instant. For example a 2.0m hose for a bandsaw which is situated close to the extractor, then swap it out for a 4.0m hose running to the table saw.
