Accessories

Convert your Nova lathe from 1 1/4” x 8TPI to 1” x 8TPI to allow the continued use of all your woodturning accessories.

RECORD POWER THREAD ADAPTOR CHUCK INSERTS FOR SC4

A 1/2" tool rest stem. This stem system enables the turner to build up a collection of tool rests without going to great expense.

A tool rest stem to fit directly into your lathe to hold the numerous cross bars and box scraper platform.

A tool rest stem to fit directly into your lathe to hold the numerous cross bars and box scraper platform.

A tool rest stem to fit directly into your lathe to hold the numerous cross bars and box scraper platform.

These crossbars are specially hardened to avoid those irritating little nicks, so that your tool moves along smoothly. Available in 4", 6" and 9" lengths.

These crossbars are specially hardened to avoid those irritating little nicks, so that your tool moves along smoothly. Available in 4", 6" and 9" lengths.

Most turners have problems with their lathe tool rest. The majority are either cast or made from low grade and tend to be relatively soft. As a result , when a square tool, like a parting tool, is used it can dig into the rest creating a series of notches. This in turn makes it very difficult to produce a smooth flow along the rest when trying to take an even cut. The cross bars from...

Taper Adaptor.

Set of 16 replacement rubber pads including screws suitable for any of the Viper Flat Jaws. Thread size is M6 x 1. Inlcudes 8 long and 8 short pads. Suitable for the following jaws V2FJ5 - 5" Flat Jaws for Viper2 V3FJ5 - 5" Flat Jaws for Viper3 V3FJ8 - 8" Flat Jaws for Viper3 V3FJ10 - 10" Flat Jaws for Viper3 V5FJ10 - 10" Flat Jaws for Viper5 W836JD - 10" Bowl Reversing Jaws for W836 Chuck

Indexing Plate for Viper2 Chuck.

Indexing Plate for Viper5 Chuck. The indexing plate fits onto the back of the Viper5 chuck, replacing the blank plate supplied as standard. It has 24 numbered positions set out at 15 degree intervals. Each position has a pin hole in the back of the plate and a slot in the side of the plate. An indexing attachment can then be used to add decorative features to a spindle or bowl at set intervals. The...

Can be used for boring up to 40" between centres. Requires CWA92 cup centre or supplied together as CWA131 Long Hole Boring Kit.

Standard fastenings spares kit for the Record Power SC3 and SC4 chucks. The kit contains 8 hex socket head screws for jaws, 3 and 4 mm hex wrenches and a blind set screw and fibre washer for chuck inserts.

Record Power Universal Spanner For SC4